Australian university’s behind-the-meter Tesla system ‘on track to meet or exceed’ expected payback

The University of Queensland team 'switch on' the Tesla Powerpack system. Image: University of Queensland.

The business case for behind-the-meter (BTM) battery storage in Australia appears to be positive, according to a University of Queensland report on the performance of a 1.1MW / 2.15MWh Tesla battery energy storage system (BESS).

A project team at the university released the results of the first quarter of operation of a Tesla Powerpack which was installed towards the end of 2019 and then put into service delivering stacked revenue streams from four different services: arbitrage, peak demand lopping, contingency frequency control ancillary services (FCAS) and a virtual cap contract. The latter is a means of hedging the University against the risk of electricity spot market price volatility.

Putting 10 of Tesla’s 215kWh commercial and industrial (C&I) Powerpacks and pushing it to 100% of nameplate depth of discharge, the total project cost AU$2.05 million (US$1.34 million), or AU$954/kWh, which the University of Queensland (UQ) was able to pay for from money earned through renewable energy credits from solar systems.

The system accrued AU$74,000 across the four services in the three months it was assessed for, with FCAS the standout leader (AU$46,000), the virtual cap contracts at just under AU$20,000 and arbitrage earning around AU$8.5k, while peak lopping was not an applicable service in the quarter as the system was not yet ready in time to perform this capability, but will be for future reporting.

UQ noted that the behind-the-meter system's performance had exceeded financial expectations by 20%. UQ did note that FCAS overperformed by 54% over expectation, due to bushfires and storm events which meant behind-the-meter storage performed more frequency control than had been anticipated.

The table below shows key performance figures. Note that the round trip efficiency figure given of 84.5%, while slightly lower than the manufacturer's stated 86.5% under nominal conditions, includes auxilliary load and is impacted by the percentage of capacity the battery started and ended the quarter with, while Q1 in Queensland includes the year's hottest months and therefore the highest auxillary cooling load requirements. 

UQ said that while one quarter alone is not a large data set to consider and that past performance may not be an accurate indicator of future performance, the results are “nonetheless a promising indication that the battery remains on track to meet or exceed its forecast 8-year payback”. There may also be future revenue streams that open up, such as markets for virtual inertia or fast frequency response. See the team's full report here.

A recent report from the Australian Energy Market Operator (AEMO) on South Australia's virtual power plant (VPP) project, which came out a few weeks ago in April and assessed the performance of aggregated residential battery storage systems from July 2019, also showed that behind-the-meter batteries could provide significant revenues, especially where FCAS services were involved.  

Key metrics for the quarter's operation of the 1.1MW / 2.15MWh BESS
Total MWh charged107.70 MWh
Total MWh discharged90.98 MWh
Round trip efficiency*84.5%
Average charge priceAU$43.20 per MWh
Average discharge price AU$149.98 per MWh
Average 'spread'AU$106.77 per MWh
Charge price vs average spot price -20%
Discharge price vs average spot price +178%
Battery availability/uptime 94.3%
Capacity factor (discharging only) 3.8%
Capacity factor (charging + discharging) 8.3%
Number of contingency FCAS events 12
Response duration of FCAS contingency events (total) 42 minutes, 36 seconds

Stay up to date with the latest news, analysis and opinions. Sign up here to the Energy-Storage.news Newsletter.